FRZ-50 concrete vibrator FRZ compressed concrete vibrator FRZ-50 modular pneumatic concrete vibrator concrete vibrator points of the wind power and vibration in two parts. Dynamic part is vane motor, flexible shaft vibrator head floating head insert pneumatic motor shaft coupling sleeve, jacket after insertion into one tight grip on pending vibrator. Pneumatic motor parts: the rotor, the cylinder, the upper and lower end caps, bearings and other components. Features: 1, the pneumatic motors use to intake side blowing compressed air from the cylinder main air duct into the cylinder, push blades, rotor drive for power operation. 2, the cylinder has eight main air duct inlet hole 6 ￠, using exhaust vent 32 ￠ 5 interleaved, so that the blades wear uniform. 3, for the relative increase in leaf width, extend the life of the rotor slotting into four equal portions radial arc groove R75, the tank is equipped with blades. 4, the pneumatic motor, 203,305 were installed under separate cover within each one radial ball bearings to withstand axial torsion. Under the cover of the skeleton has a J-type seals prevent air pneumatic motor under channeling, which effectively ensure pneumatic motor drive reliability and stability work and life. Technical Specifications: Diameter: 50 mm Length: 8000 mm power: wind vane motor rated speed: 3000 r / min using pressure: 0.4-0.5 MPa load air consumption: 1.5 m 3 / min Total weight (with vibrator ): 32 kg pneumatic vibration club head diameter: 32,38,50,70mm choose pneumatic vibrator shafts hose length: 4M, 6M, 8M, 10M of equal length for selection